New Slitting Cutters with Coolant Channels Carrying TANG-GRIP Inserts
Highlights
ISCAR is expanding the TANGSLIT slitting cutters by adding TGSF-JHP cutters with coolant channels directed to each and every cutting edge and SW/S-JHP driving shanks that can convey the coolant to the cutters
TGSF-JHP Cutter Features
63-125 mm Cutter diameter
3.0 and 4.0 mm Slitting widths
Advantages
Coolant channels directed to each and every cutting edge
Efficient cooling that prevents built-up edge, thus substantially prolonging tool life
Higher productivity as cutting speed can be raised up to 50%
An ideal solution for machining high temperature alloys and stainless steel
Very efficient chip disposal and improved surface finish
Advantageous for both low (10 bar) and high (340 bar) coolant pressure
SW/S-JHP Shank Features
25.0 and 32 mm shank diameters
Shell holder with 32.0 mm adaptation
Tool: TGSF 63-4-10K JHP
Insert: TAG N4J IC830
Conventional coolant 8 bars
JHP 50 bars
The new slitting cutters provide a winning solution for slitting, especially for high temperature alloys
and stainless steel.
TGSF-JHP
Slitting Cutters with Coolant Channels Carrying TANG-GRIP Inserts
• ETG extractor should be ordered separately
(1) Number of inserts Note: Parameter designations are according to ISO13399 standard.
* Optional, should be ordered separately
SW/S-JHP
Drive Shanks with Coolant Channels for TANG-GRIP Slitting Cutters
(1) Item weight Note: Parameter designations are according to ISO13399 standard.
See below insert information for several popular geometries
(other chipformers can also be used)
TAG N-C/W
Single-Ended Inserts for Parting, Grooving and Slitting Bars,
Hard Materials and Tough Applications
• Feed values for grade IC20 should be decreased by 50%
TAG N-J/JT
Single-Ended Inserts for Parting, Grooving and Slitting Soft Materials
• JT chipformer has the basic positive configuration of the J-type and a reinforced negative frontal edge; most suitable for soft materials at low to medium feeds.
Machining Data for Slitting with TANGSLIT Cutters
For machining aluminum, use IC20; maximum cutting speed
corresponds to the maximum RPM indicated on the cutter
Recommendations are for normal machining conditions
If excessive wear occurs, select insert with higher hardness
If chipping or breakage occurs, select insert with more toughness
